Browning Hi-Power Pistols

After a Hi-Power pistol has been fired, and the barrel and slide move rearward a short distance together as a unit. What system unlocks and locks the gun?

The link Lock system
The cam lock system
The toggle lock system
The roller lock system

What part of a Hi-Power pistol makes contact with the sear to trips the hammer and fire the gun?

The trigger
The trigger bar (sear lever)
The trigger lever (trigger connector)
The actuator

Which one of the following statements about the Browning Hi-Power pistol’s magazine disconnector system is correct?

There is no magazine disconnect system found in the design of the Hi-Power pistol.
The magazine disconnect system is enable when the magazine is out of the magazine well, which allows the spring-loaded magazine safety to move forward. This causes the trigger connector (trigger lever) to move rearward enough so that it doesn’t make contact with the trigger bar (sear lever) if the trigger was pulled, thus preventing the gun from being fired. When the magazine is inserted back into the pistol, it pushes the magazine safety rearward, causing the trigger connector to move forward, enabling the trigger connector to make contact with the trigger bar, which enables the gun to be fired when the trigger is pulled.
The magazine disconnect system is enable when the magazine is out of the magazine well, which allows the spring-loaded magazine safety to move rearward. This causes the trigger connector (trigger lever) to move forward enough so that it doesn’t make contact with the trigger bar (sear lever) if the trigger was pulled, thus preventing the gun from being fired. When the magazine is inserted back into the pistol, it pushes the magazine safety forward, causing the trigger connector to move rearward, enabling the trigger connector to make contact with the trigger bar, which enables the gun to be fired when the trigger is pulled.
The magazine disconnect system is enabled when the magazine is out of the magazine well, which allows the spring-loaded magazine safety to move forward. This causes the trigger connector (trigger lever) to move rearward enough so that it makes contact with the trigger bar (sear lever) if the trigger was pulled, thus preventing the gun from being fired. When the magazine is inserted back into the pistol, it pushes the magazine safety forward, causing the trigger connector to move forward, enabling the trigger connector to make contact with the trigger bar, which enables the gun to be fired when the trigger is pulled.

What does the manual/thumb safety block on a Hi-Power pistol when it is set to the safety “On” position?

The trigger
The sear
The hammer
The manual safety lifts the trigger too high for the trigger connector to hit it

Quiz Summary

Information

Results

Results

Categories

1. Question

2. Question

3. Question

4. Question